+7 (495) 797-3311

*
E-mail *
*
* - ,
QTECH - Quality Technology
Ethernet
PON
TDM
VoIP
3G
ADSL-
ETHERNET
ETHERNET
IP
IP
IP
IP
IP
LTE
SHDSL-
WI-FI
WI-FI QWR
WI-FI
WI-FI
WI-FI
GPON ONU
GPON
( )
-
-
ETHERNET
(NVR)
SFP+
 
XFP
Q-STICK
PDH
PDH
(SAN)
ERICSSON
SDH
FTTB/FTTH
WDM- QWM-7200
SDN
(NVR)
- Q-WAY
WI-FI
VOIP
(SAN)
WI-FI
ERICSSON
C XWDM
 


IOT  QTECH
 
: / / / SFP+ / QSC-SFP+


QSC-SFP+


:

:

Parameter Unit Values
Operating Reach m 10 -20 KM
Transmit
Center wavelength (range) nm 1260 -1355
Side Mode Suppression Ratio (min) dB 30
Launched power
maximum dBm +0.5
minimum dBm -8.2 Notes1
OMA dBm -5.2
OMA-TDP (min) dBm -6.2
Transmitter and dispersion penalty dB 0 Notes4
Average launch power of OFF transmitter (max) dBm -30
Extinction ratio (min) dB 3.5 Notes2
RIN12 OMA (max) dB/Hz -128
Optical Return Loss Tolerance (min) dB 12
Receiver
Center wavelength (range) nm 1260-1355
Receive overload (max) in average power1 dBm 0.5
Receive sensitivity (min) in average power1 dBm -14 Notes3 (10km)
dBm -13 Notes3 (20km)
Receiver sensitivity (max) in OMA (footnote 2) dBm -12 Notes3 (10km)
dBm -11 Notes3 (20km)
Receiver Reflectance (max) dB -12
Stressed receiver sensitivity (max) in OMA2 dBm -10.3
Vertical eye closure penalty (min)3 dB 2.2
Stressed eye jitter (min)2 UIp-p 0.7
Receive electrical 3dB upper cutoff frequency (max) GHz 12.3
Receiver power (damage, Max) dBm 1.5

Notes:
The optical power is launched into SMF
Measured with a PRBS 231-1 test pattern@10.3125Gbps
Measured with a PRBS 231-1 test pattern@10.3125Gbps BER?10-12
4. In G.652 and G.655(NDSF)

:

Parameter Symbol Min. Typical Max Unit Notes
Data Rate   - 10.3125 - Gbps  
Power Consumption   - 1200 1500 mW  
Transmit
Single Ended Output Voltage Tolerance   -0.3 - 4.0 V  
Common mode voltage tolerance   15 - - mV  
Tx Input Diff Voltage VI 400   1600 mV  
Tx Fault VoL -0.3 nbsp; 0.4 V At 0.7mA
Data Dependent Input Jitter DDJ     0.10 UI  
Data Input Total Jitter TJ     0.28 UI  
Receiver
Single Ended Output Voltage Tolerance   -0.3 - 4.0 V  
Rx Output Diff Voltage Vo 300   850 mV  
Rx Output Rise and Fall Time Tr/Tf 30     ps 20% to 80%
Total Jitter TJ     0.70 UI  
Deterministic Jitter DJ     0.42 UI  

:

Parameter Symbol Min. Max Unit
Power Supply Voltage VCC 0 +3.6 V
Storage Temperature Tc -40 +85 °C
Operating Case Temperature Tc -5 +70 °C
Relative Humidity RH 5 95 %
RX Input Average Power Pmax - 0 dBm


:

SFP+ (Hot plug). 0.8 20 SFF-8083.




:

Contacts logic Symbol Power Sequence Order Name/Description
1   VeeT 1st Module Transmitter Ground
2 LVTTL -O TX_Fault 3rd Module Transmitter Fault
3 LVTTL-I TX_Disable 3rd Transmitter Disable; Turns off transmitter laser output
4 LVTTL-I/O SDA 3rd 2-wire Serial Interface Data Line (Same as MOD-DEF2 in the INF-8074i)
5 LVTTL-I/O SCL 3rd 2-wire Serial Interface Clock (Same as MOD-DEF1 in the INF-8074i)
6 Mod_ABS 3rd Module Absent, connected to VeeT or VeeR in the module
7 LVTTL-I RSo 3rd Rate Select 0, optionally controls SFP+ module receiver. When high input signaling rate > 4.25 GBd and when low input signaling rate ≤ 4.25 GBd.
8 LVTTL -O Rx_LOS 3rd Receiver Loss of Signal Indication (In FC designated as Rx_LOS and in Ethernet designated as Signal Detect)
9 LVTTL-I RS1 3rd Rate Select 1, optionally controls SFP+ transmitter. When high input signaling rate > 4.25 GBd and when low input signaling rate ≤ 4.25 GBd.
10 VeeR 1st Module Receiver Ground
11 VeeR 1st Module Receiver Ground
12 CML-O RD- 3rd Receiver Inverted Data Output
13 CML-O RD+ 3rd Receiver Non-Inverted Data Output
14 VeeR 1st Module Receiver Ground
15 VeeR 2nd Module Receiver 3.3 V Supply
16 VeeT 2nd Module Transmitter 3.3 V Supply
17 VeeT 1st Module Transmitter Ground
18 CML-I TD+ 3rd Transmitter Non-Inverted Data Input
19 CML-I TD- 3rd Transmitter Inverted Data Input
20 VeeT 1st Module Transmitter Ground



QSC-SFP+
*
E-mail *
*

( 5 )
* - ,